American Car Craft Prowler Front Grille Emblem Retro Kat Logo Polished 1Pc 1997-2002 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
Prowler 3-D Retro Kat Grille Emblem 1Pc - Polished
Part #822041
GENERAL PART INSTALLATION INSTRUCTIONS
PARTS INCLUDED:
1-Oval Kat Logo
1-Adhesive Promoter Pack
Introduction: In the next few paragraphs we will explain to you what you will need to know and do for a successful
application of ACC Stainless Steel Accessories. It is important to understand that almost all stainless steel peel and stick
accessories need to be pre shaped by hand in order to achieve a nice long term installation. We realize that all parts are
different from each other but as far as the installations of these parts they all will need to follow the same set of general
instructions.
Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place until the
installation is complete to prevent finger prints and or possible scratches during installation. This liner is required to
remain on the part until you are instructed to remove it.
1. IMPORTANT: Clean grille in the area you will mount the logo first with soap and water to remove any
dirt then - with household Isopropyl Alcohol or rubbing alcohol.
You MUST remove even the slightest dirt and especially oil (even oil from your fingers) from the grille
surface. Let dry for 3 minutes.
2. Take the logo and without removing the backing put it up to your grille and see where you want to
mount it. It is whatever looks best to you.
You will want to hand bend the emblem so it rests along the bend of the grille without forcing it down.
3. Take your grille logo and pull off the red backing on the backside. This will expose the sticky tape
back. Try not to touch the stick back with your fingers or anything else.