American Car Craft Corvette Dry Sump Oil Tank Cover Polished 2006-2013 Z06+GS only User Manual
Page 2
the factory clip off the wiper cowl then hold the support bracket in place and force the clip back onto the cowl
securing the support bracket.
3. With the bracket in place position the new cover so that you will be able to mark the thumb screw hole to the
hoods safety hook platform with a marker. Remove the cover and then drill a 5/32 pilot hole at that location.
You have been provided with a single pilot screw of the same thread type. Use this screw to create the thread
into your newly piloted hole by using a screw gun to run the screw in and out of the hole a few times to create a
nice thread path for the thumb screw. Do not try to thread the thumb screw in before this procedure because
this will damage the thumb screw. You want to be able to freely insert the thumb screw without binding. If the
thumb screw binds run the pilot screw through again until you can achieve a nice free moving installation of the
thumb screw. Your new cover will have a Velcro strip adhered to the underside this will connect to the Velcro
attached to the bracket installed earlier.
4. Now that you have got everything ready simply set the new cover into place and secure it with the thumb screw
provided. Remove the protective liner.
If any questions or problems occur during installation, please contact American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520