American Car Craft Corvette Headlight Eyebrow Kit 2Pc Chrome ABS 2005-2013 C6 all - Manual (Page 2)

headlight. Apply a small bead of the adhesive promoter from the tube
(provided) around the edge of the headlight. Then begin placing the trim
starting at the body seam by the headlights edge directly to the top side of the
lens NOT to the side of the lens covering the 1/8” gap created during
placement. Work your way around to the start point pulling the red release
liner as you go. As you approach each corner pre-bend the trim between
your fingers and your thumb so that the trim takes the shape of each corner
without forcing. Allow the trim to slightly strap the side of the lens at the two
corners only. (Please refer to pictures). Then continue to pull release liner
and set in position. Once you come to the start point mark the overlap
slightly longer then trim the molding on the mark with a pair of scissors.
Buckle the two ends together and press firmly to set a nice tight seam. Press
the entire trim to permanently set. Repeat steps 1-3 for opposite side. TECH
TIP: Use a little instant adhesive at the butt seam to eliminate separation or
shrinkage of the molding over time.
DO NOT GET WET FOR 24 HOURS!
IF ANY QUESTIONS OCCUR DURING INSTALLATION PLEASE CONTACT
AMERICAN CAR CRAFT AT 727-861-1500.
Thank You and Enjoy Your New Purchase.
(Please note pictures shown are general application guides and may not represent your
particular application)
1/8” Space
Here