American Car Craft Camaro Inner Fender Covers Perforated Deluxe 10Pc w_Fuse Box Cover 2010-2011 User Manual
Page 3
the hole for better accuracy. It all depends on your cars final bolt position. Should this become necessary all you will
need to do is to slightly adjust the holes opening with a pointed die grinder. This common shop tool will allow you to
make this adjustment in a few seconds without warping and or damaging the metal surface. Be careful not to over
tighten these two screws at any time as this may result in snapping the screw into the bolt. Just snug will do fine.
2. Once the two screws have been installed mark the clip location of the back of the panel to the wiper cowl. You have
been provided with two small strips of black furry tape. This tape has been supplied to be placed at the contact point of
the panel to protect the wiper cowl from damage. Remove the panel and then swipe the spot with the adhesive
promoter provided. Apply the tape allowing it to roll over the front of the cowl ridge to the underside and then press
firmly to set it. Reinstall the new cover and peel the protective liner at both screw locations and then reinstall the two
screws. You have been provided with 4 furry ¾” Velcro donuts, peel the release liner from the back of these donuts and
place them over the 4 screw heads you just installed then press on the 1''chrome screw covers provided. Perform this
same procedure for the opposite side and then remove the protective liner from both fender covers.
3. You have been provided with a chrome decorative positive terminal cover. This cover will just set over the red factory
terminal cover.
4. The last thing to do will be to set the fuse box cover plate into position over the box to determine its position. Before
you permanently stick the panel in place hold it to the fuse box cover and release the cover from the fuse panel opening
it and closing it to make sure the new cover sits back far enough to allow you to operate the door without binding on the
new fender cover and or the new radiator support cover if you are planning to install one. Once you have a good idea
about how it will sit scrub the top of the factory cover with alcohol and then swipe the cover with the adhesive
promoter provided. Allow a few seconds to dry and then peel the release liner from the 4 attachment cookies on the
underside of the new cover and carefully set it into the correct position pressing firmly to set.
Remove the protective liner to finish the installation.
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520