beautypg.com

American Car Craft Ford Raptor Hood Panel Etched Vanity Plate only 2010-2013 User Manual

American Car Craft For the car

background image




AMERICAN CAR CRAFT INSTRUCTIONS

FORD RAPTOR ETCHED VANITY PLATE INSERT

PART # 773007

patent pending

PARTS INLUDED:
___1-Stainless Hood Insert
___1-Small Scuff Pad
___1-Adhesive Promoter Pack

Your new panel comes to you with a protective liner. Do not remove liner until installation
is complete.


1. You have been provided with a small scotch pad. Use this pad to scuff the area where
you will be installing your new insert. This will create a nice bondable surface. Once you
have scuffed the area you will need to thoroughly clean the surface by scrubbing it with
rubbing alcohol and wiping off any and all residues with paper towels.

2. You will notice the insert contain a 3M attachment tape border this will attach to the
border around the hood inset area. The inner border of the hood inset area will need to be
specially treated by swiping it once with the adhesive promoter provided. This will
provide an accelerated bondable surface for the insert to attach to. NOTE: The adhesive
promoter is to be applied to this 1’’ border only and not to the larger main surface area.