American Car Craft Corvette Water Tank Cover Polished w_caps - 2005-2013 C6 Automatic only - Manual

AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com
C6 CORVETTE COMPONENT WATER TANK COVER
PART# 043013
patent pending
INSTALLATION INSTRUCTIONS
PARTS INCLUDED:
___1-Stainless Water Tank Cover
___1-Decorative Hose Collar
___1-Adhesive Promoter
___2-Decorative Chrome Caps w/Velcro Cookies for #C634 (1-3/4) and 1-full Cap
W/Notch.
Your new accessory comes to you with a clear protective liner. This liner will help to
keep your new parts clean during installation. You will be instructed when to remove the
liner during the detailed installation.
YOUR NEW COVER HAS BEEN DESIGNED TO DRAMATICALLY ENHANCE
THE LOOK OF THE FACTORY OVERFLOW TANK AND WILL ADD A REALLY
NICE CUSTOM LOOK TO YOUR ENGINE BAY.
1. Using a pair of vice grips clamp the top flow hose so that when you remove it, it
will not leak any fluid. Using a regular plier’s squeeze the hose clamp to remove
the hose. Hold the hose straight up and lower the vise grip down some. Use a
paper towel to soak out the fluid in the hose. Remove the hose clamp.
2. Slide the decorative hose collar over the hose so that the large opening of the
collar faces towards the tank. Slide it down the tube enough to allow you to re-
install the hose clamp.
3. Remove the factory water tank cap and the windshield washer fluid cap. You will
notice that the water tank has a plastic overflow tube set into a hole retainer
attached to the tank. Pull this tube out of this retainer and allow it to lie next to it
outside of the hole.