American Car Craft Corvette Nose Cap Front Polished 2005-2007 C6 only - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C6 CORVETTE FRONT NOSE CAP (fit 2005-2007)
PART # 043019
patent pending
ITEMS NEEDED: ITEMS PROVIDED:
Household Isopropyl Alcohol 4-Speed Clips
Small Socket Set 4- Flat Head Screws
Right Angle Pick Adhesive Promoter
Your new nose cap is designed as an optional finish to our radiator cover and is
not made to stand alone your radiator cover must be installed first. Your nose
cap comes to you with a protective liner; do not remove liner until final step.
1. Remove the bumper screws and factory clip nuts attaching the nose piece to
the steel bumper. A right angle pick works best for this. Replace with the four
speed clips and flat head screws provided. Tighten to a snug and flush position.
The flat head screw will countersink itself as long as it is not over tightened.
2. Prep the entire area first with household isopropyl alcohol then wipe with the
adhesive promoter provided. Be sure not to miss the area just under the rubber
seal.
3. Your new nose piece is designed to permanently attach to the nose area via
3M attachment tape. Remove the red liner from the tape and line up the nose
cap with the ACC Radiator Cover from side to side and just under the rubber seal
molding. Be sure to catch the entire small ridge running just under this molding