American Car Craft Corvette Engine Shroud Side Inserts 2Pc Perforated Illuminated 2009-2013 ZR1 only - Manual (Page 2)

illuminated version) thru the piloted hole you created earlier if your part is illuminated and then remove the red release
liner form the back of the each insert and then carefully set them in place pressing firmly to set.
3. If your installation is illuminate you will need to turn the factory should over and install the wires by routing them
over to the passenger side. Apply a tiny drop of instant adhesive to set the wire along the inner rim of the factory shroud
securing the wire until you reach the passenger side of the cover. . .you have been provided with a pigtail wire plug to
enable you to release the cover when this becomes necessary.
If any questions or problems occur during installation, please contact American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com