American Car Craft Corvette Radiator Cover - End Caps Polished 1997-2004 C5 & Z06 User Manual
American car craft instructions
AMERICAN CAR CRAFT INSTRUCTIONS
DESCRIPTION C5 Radiator Cover Polished End Caps
PART #033059
Parts Included:
2-Stainless End Caps
Introduction: This optional accessory has been designed as the finishing touch for the ACC C5 Radiator Cover.
The part will work for both the smooth #033057 and perforated #033058 versions and is easy to install in just
a few steps.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in
place until the installation is complete to prevent finger prints and or possible scratches during installation.
1. Remove the two ten millimeter bolts securing the factory black plastic radiator support.
2. You will notice that the part will contain a small tap rolled over at the top corner of each part. (driver
side & passenger side) This tap has been designed to slip into the top corner of the component
radiator cover. If you look closely at this side area towards the front of the car you will notice a small
channel. Slip the tab of the part into the channel of the cover and then line up the two holes at the
base of the part with the hole you exposed earlier when you removed the factory bolts.
3. Once you have the part correctly inserted and lined up simply remove the protective liner and then
reinstall the factory bolts.
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520