American Car Craft Camaro Inner Fender Liners Polished 4pc w_Lit Top Caps w_aftermarket hood 2010-2013 User Manual
Page 2
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in
place until the installation is complete to prevent finger prints and or possible scratches during installation.
1. The first step will be to prepare the inner fender ridges to receive the parts. Thoroughly scrub clean the
upper inside area of each fender with alcohol to remove any and all road grime and dirt. Then swipe the
areas with the adhesive promoter provided.
2. Before you actually stick anything take a moment to place each section of the four piece kit into their areas
to get acquainted with their positions and just how you will place the sections. This is important because
the adhesive of each piece is very aggressive and will not allow you to reposition any section should they
make contact in the wrong spot without damaging them so go slow and sure. The first section to go in will
be the self-stick bracket. These brackets will contain several notches that will correlate with the fender
guests running along the fenders inner edge. Once you have determined how they will sit peel the red
release liner from the back of the bracket and then carefully set it into position pressing firmly to set the
bond. Then mount the remaining bracket opposite side.
3. The next step will be to set the red light rail. It is important that you first place the rail in position over the
brackets to take a look at the back edge of the rail and make sure there is enough space between the rail
and the hood hinge. Once you have determined the right position peel the red release liner from the back
of the rail and carefully set it in place pressing firmly to set. Properly placed rail will sit nice and tight to the
fender edge allowing complete freedom of the hood hinge to go up and down. Once you have successfully
installed both light rails remove the protective liner and wrought the wires over to the passenger side
positive terminal. At this time in the installation you can proceed to connect the red light system to
whatever type of switching system you will use such as a wireless remote and or manual type switch. You
have been provided with a fuse holder and 5amp fuse. It is important not to exceed this amperage as this
will damage the LED’s. It is also important to understand that the Led lights will only operate in the correct
polarity black wire to ground and black wire with color tracer to the positive terminal of your switch.
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520