American Car Craft Corvette Headlight Aggressive Eyebrow Kit 2Pc - Chrome ABS 2005-2013 C6 all - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C6 Corvette Chrome Aggressive ABS Eyebrow Kit
Part#042033
patent pending
PARTS INCLUDED:
2-Chrome Eyebrows
2-Chrome Molding Strips
1-Adhesive Promoter Pack
1-Adhesive Promoter Tube
1-Plastic Squeegee
Your new headlight kit comes to you with a clear protective liner. Do not remove the
liner until the end of step 2.
1. Clean your headlight first with soap and water and then with household
isopropyl alcohol and let dry. Then swipe the area ONLY where you will be
placing your new cover with the adhesive promoter packet (provided). BE
CAREFUL NOT to apply the adhesive promoter to the clear area of the lens
where the chrome will not be covering because it will leave a visible smear. If
a smear occurs simply remove it with household rubbing alcohol after the
installation is complete. Once you have carefully applied the adhesive
promoter correctly you may begin the installation.
2. Please refer to pictures as you continue thru steps 2 and 3. Place the new
cover over the headlight so that it fits along the upper edge of the headlight
and make note of its position. If positioned correctly you will have about a
1/8” space between the edge of the eyebrow and the edge of the light. NOTE:
This space will be covered by the chrome trim in the following steps. Once
this position is clear you may begin permanent installation by peeling the
release liner of the underside and carefully reposition the new cover starting
from the small side and working your way to the larger section making sure
that you use the plastic squeegee (provided) to press down on the cover nice
and evenly to attach it without any air pockets. Remove the protective liner.
3. You have been provided with a length of chrome trim. This trim is designed
to cap the headlight cover you just installed and to border the entire
headlight. Apply a small bead of the adhesive promoter from the tube