American Car Craft Corvette Inner Fender Accent Plates Polished 1997-2004 C5 & Z06 User Manual
Page 2
1. Thoroughly clean the fender area with household isopropyl alcohol to remove any
and all road grime and dirt. Once clean swipe the area to be mounted once with
the adhesive promoter provided.
2. Before installing your new covers you will need to create some clearances
between the headlight motor and the actual wheel well by pushing the small wire
harness that rests just under the motor forward in such a way that they will fall to
the front of the wheel well. Doing this will allow the new fender covers to fit
under the two motors.
3. Once you have created the needed clearance insert the panels to check the fit.
Once you are satisfied with the placement and fit peel the release liner from the
attachment tape on the back of each cover then press firmly to set in place.
4. Remove protective liner.
Note: Care must be taken when cleaning your covers. It is a good idea to lightly
dust your covers with a clean soft cloth first in order to prevent any particles from
scratching them. Then wipe (using a new clean soft cloth) with a good quality
streak free glass cleaner. SEE ENCLOSED CARE SHEET!
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new cover.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520