American Car Craft Corvette Exhaust Filler Panel for Borla Stinger Exhaust with Quad Oval Tips Plain Polished 1997-2004 C5 & Z06 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
Borla Stinger Quad Oval Polished Exhaust Filler Panel
PART#032008
PART INCLUDED:
___1-Stainless Panel
___2-Small Self Tapping Screws
NOTE: Your new exhaust port filler panel is designed to fit over the exhaust and is
sandwiched between the exhaust pipes and the urethane bumper. (see pics. 2&3)
Your new panel comes to you with a protective liner. Do not remove until your
installation is complete!
1. Your new panel comes to you flat – in order to achieve a nice snug fit it will
be necessary to slightly curve the filler panels’ left and right side. (see pic. 1).
2. Carefully place your filler panel over the exhaust pipes until it reaches the
black fiberglass underbody between the pipes. With your forefinger, force
the bottom section of the filler panel until the bent tab snaps under the car.
(see pics. 2,3,4&5).
Please note: We have made a small change to these which will allow the
panel to be more visible. To make the installation a bit easier, enlist the
help of a second person to handle the sides while you push it in place in
the center.
3. At this point the panel fits pretty snug. You will notice slight gaps at the right
and left corners. Simply pull the panel to form its shape until it contours to
the shape of the car. (see pics. 6,7,8&9).
4. Once you are satisfied with the shape line up your panel so that it sits in the
center and your right and left corners line up with the urethane bumper. (see
pic. 10).
5. You have been provided with two washer head self-tapping screws. Fasten
your filler panel in position at the two mounting holes located at the
underside of the panel. (see pics. 11&12).