American Car Craft HHR Door Arm Trim Brushed 4Pc 2009-2012 +SS User Manual
Page 2
PLEASE NOTE:
Installation errors are NOT
manufacturing defects and parts can NOT be
RETURNED due to improper installation.
1. Once your areas have been prepared use the adhesive promoter
packs/tubes (provided) to wipe the areas of your dash/door that will be
covered with your new stainless pieces. Allow a few seconds to dry. You
have been provided with attachment tape test strips. Use one of these to test
the tack. If it seams to stick well then you can proceed with your installation.
If you can not get the test tape to stick please refer back to the special
preparation instruction sheet and repeat those procedures.
2. Before you remove the liner for permanent attachment place each piece
into position and check the fit and also get acquainted with just how each
part sets in place. It will be necessary to form a few of the parts by hand to
conform to the shape of your dash to insure a nice perfect fit without
forcing the shape. Once you are satisfied with the shape and fit peel the
red release liner and firmly press each piece into position.
If any questions occur during installation please contact American Car Craft @
727-861-1500
Thank you and enjoy your purchase!
Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good
idea to lightly dust your kit with a clean soft cloth first in order to prevent any
particles from scratching it. Then wipe (using a new clean soft cloth) with a good
quality streak free glass cleaner.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520