American Car Craft Corvette Plenum Cover Perforated Low Profile 2006-2013 Z06 only - Manual (Page 2)

with household isopropyl alcohol. (This is where your new plenum cover will sit).
Let dry then wipe same area with the adhesive promoter (provided).
2. Your new cover has 2 Velcro strips of attachment tape on its underside. Remove
the hook side from both strips and set aside for a moment. Place your new cover
on top of the factory fuel rail covers and line up so that it appears nice and straight
and flush with the back gasket ridge.
3. The next step is to place a length of masking tape on either side of the new
plenum cover directly onto both factory fuel rail covers. Doing this will indicate
where the new cover sits.
4. Next apply the Velcro hook strips along the inside edge of the tape you just
placed (the hook strips will be under your new plenum cover) and press firmly to
set. Remove the masking tape.
5. Now you can install the new cover by simply pressing into position. It may be
necessary to slightly lift and nudge the new cover in order to achieve a nice
straight fit.
INSTALLATION TIP: Although this procedure should not be necessary with a
clean and proper installation you may apply 2 or 3 rivets thru the hook side of the
Velcro into your factory fuel rails on both sides to insure that the Velcro stays in
place.
NOTE: Care must be taken when cleaning your cover. It is a good idea to lightly dust
your cover with a clean soft cloth first in order to prevent any particles from scratching it.
Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com