American Car Craft Dodge Charger _ Chrysler 300 Door Lock Trim Ring 4Pc 2011-2013 User Manual
American car craft instructions, Very important, Attachment tape test strips

AMERICAN CAR CRAFT INSTRUCTIONS
DESCRIPTION Charger 4pc Door Lock Trim
PART #331006
Parts Included
4-Stainless Trim Rings
1iAdhesive Promoter Tube
Introduction:
Dress up the interior of your
NEW
2011-2012 Dodge Charger with our Polished
Stainless 4pc Door Lock Trim! These trim rings are made from the finest T304 polished
stainless and have been designed to attach using 3M attachment tape. Easy Installation,
compliments our complete interior stainless trim accessories. Will never tarnish, rust or pit!
!!!!!!!VERY IMPORTANT!!!!!
BEFORE YOU BEGIN YOU MUST FIRST PREP YOUR DASH/DOOR AREAS WHERE PIECES ARE
GOING TO BE INSTALLED IN ORDER TO ALLOW ADHESION!!!!. You can do this by scrubbing the entire
area first with household isopropyl alcohol.
NOTE: If these areas have been treated with armor all or any such
surface protector; installation will NOT work unless these treatments have first been removed using special
chemicals. PLEASE REFER TO THE SPECIAL PREPARATION INSTRUCTION SHEET ENCLOSED.
We cannot be responsible for kits not sticking do to improper preparation!
PLEASE NOTE:
Installation errors are NOT manufacturing defects and
parts can NOT be RETURNED due to improper installation.
1. Once your areas have been prepared use the adhesive promoter packs/tubes (provided) to wipe the
areas of your dash/door that will be covered with your new stainless pieces. Allow a few seconds to dry.
You have been provided with
attachment tape test strips
. Use one of these to test the tack. If
it seems to stick well then you can proceed with your installation. If you cannot get the test tape to stick
please refer back to the special preparation instruction sheet and repeat those procedures.
2. IMPORTANT!! Before you remove the liner for permanent attachment place each piece into position
and check the fit and also get acquainted with just how each part sets in place. It WILL be necessary to
form a few of the parts by hand to CONFORM to the shape of your dash to insure a nice perfect fit
without forcing the shape. Once you are satisfied with the shape and fit peel the red release liner and
firmly press each piece into position.
If any questions occur during installation please contact American Car Craft @ 727 861-1500.