American Car Craft Corvette Interior Door Reflector Polished Trim 1997-2004 C5 & Z06 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C5/Z06 Door Reflector
PART#031044
PARTS INCLUDED:
___2-Stainless Side Marker Trim
___1-Adhesive Promoter Pack
___1-Adhesive Promoter Tube
___2-16” Lengths ¼” Chrome Trim
Quick installation tip would be to pull out the door reflector and it will make it a lot
easier to install..it’s just a push clip on the bottom of the reflector and 2 tabs on the top.
Remove by unclipped the lower clip and slide it out towards the bottom to release the
tabs.
1. Thoroughly clean the factory plastic side marker with alcohol to remove any and
all wax and dirt. Once this has been done swipe the entire factory lens with the
adhesive promoter pack provided (save enough promoter for the opposite side)
allow a few second to dry.
2. Before you permanently attach the stainless bezel set it in place to get acquainted
with its position. A properly placed bezel will set perfectly centered evenly all
around the perimeter of the factory lens. Once you can see just how it sets in
place, peel the release liner from the back of your new bezel and carefully set in
place. Press firmly along the entire stainless bezel to make sure you have a nice
complete bond.