American Car Craft Camaro Power Steering Cover Polished 2010-2013 User Manual
American car craft instructions, Camaro power steering cover
AMERICAN CAR CRAFT INSTRUCTIONS
Camaro Power Steering Cover
PART #103040
Parts Included:
1-Stainless Cover
1-Decorative Cap Cover
1-Adhesive Promoter Pack
Introduction: This new and unique all stainless cover is the only available cover for the 2010 to current 8 cylinder or SS model
engines power steering reservoir and pump. It is designed to be used WITHOUT the factory engine shroud for applications such as
super chargers and other engine modifications requiring the removal of the V8 engine shroud. This cover is NOT designed to fit V6.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until the
installation is complete to prevent finger prints and or possible scratches during installation.
1. Once you have permanently removed the engine shroud you will notice the power steering pump. Your new cover is
designed to fit directly over the pump by removing the factory power steering pump cap then set the new cover in place
and then reinstall the factory cap. This is the only mechanism required to hold your new cover in position. Remove the
protective liner.
2. Thoroughly scrub clean the top surface of the factory cap with alcohol to remove any road grime and dirt. Then swipe the
cap with the adhesive promoter provided. Then simply remove the Velcro cookie under the decorative cap cover supplied
with your kit and peel the release liner from the cookie and then press it to the factory cap. Then simply set the decorative
cap in place to finish the installation.
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520