beautypg.com

American Car Craft Corvette Fuel Rail Covers Replacement Style Perforated 2006-2013 Z06 only User Manual

American car craft instructions

background image

AMERICAN CAR CRAFT INSTRUCTIONS

C6 2006-2013 Z06 FUEL RAIL COVERS PERFORATED REPLACEMENT STYLE

PART #043087

Parts Included:
2- Stainless Installation Brackets w/Velcro attached
4- Clip nuts
4-3/4 washer head type screws
1-3/8” Vacuum Cap
1-Adhesive Promoter Packet
1-Decorative Chrome Cap w/ butyl attachment putty
2- Stainless Perforated Replacement Covers

Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation.

1. Remove the two factory fuel rail covers and set aside.

2. Starting with the driver’s side and remove the wire harness secured at the two tabs protruding from the factory

fuel rail. You can do this by pulling up on the harness to release it at the two attachment points of the harness.
Tuck the harness down and out of the way. You have been supplied with two identical installation brackets.
These brackets come to you bent in such a way as to allow you to install them at the two holes locations you just
exposed at the side of the fuel rail. You have been provided with four clip nuts two for the driver side and two
for the passenger side. Now that you have exposed the holes in the fuel rail tabs slip the clip nuts over these two
areas so the threaded half of the clip nut faces towards the engine. You have been provided with two stainless
steel attachment brackets. The two brackets are slightly bent so that when you align the holes in the brackets
with the holes in the fuel rail they will roll over the top of the fuel rail providing an attachment point for the new