American Car Craft Corvette Headlight Buckets 2Pc Deluxe Polished 1997-2004 C5 & Z06 User Manual
American car craft instructions

AMERICAN CAR CRAFT INSTRUCTIONS
DESCRIPTION C5 POLISHED DELUXE HEADLIGHT BUCKETS
PART #033072
Parts Included:
2-Stainless Headlight Bucket Covers
4-1 ¼” Long Washer Head Type Screws
4-3/4” GM Threaded Washer Head Type Screws
Introduction: Installation instructions for the application of the C5 deluxe headlight buckets. This new
headlight bucket has been designed to wrap around the side as well as the back side closing in an unsightly area.
The covers come to you flat and must be manually shaped by hand.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in
place until the installation is complete to prevent finger prints and or possible scratches during installation.
1. The first step will be to open the hood. Place some masking tape to the edge of your hood as well as the
headlights top hat to protect the paint as you are shaping the new covers. Remove the large black cap
located on the side of the factory headlight bucket. NOTE: The factory headlight bucket stays in place
for this installation and this large cap will not be reused.
2. Place the correct cover in place to the side of the factory bucket and then roll the new cover so that you
match the shape of the inside corner of the headlights top hat. Shape the new cover so that it does not
wrap around the headlight motor. A properly shaped cover will not touch the headlight motor at all and
can be achieved by gently and patiently forming the new cover until it is shaped just right.
3. Once you have achieved a nice contoured shape remove the two factory screws on the side of the
headlight as well as the two in the back of the headlight. NOTE: These screws will not be reused. You
have been supplied with four 1 ¼’’long washer head type screws and four ¾’’ Gm threaded washer head