American Car Craft Corvette Exhaust Filler Panel Flowmaster Quad Tips Polished 2005-2013 C6 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C-6 FLOWMASTER EXAUST PORT FILLER PANEL POLISHED
PART#042025
PARTS INCLUDED:
___2-pc STAINLESS FILLER PANEL
___2-ADHESIVE PROMOTER PACKS
___2-1’’WASHER HEAD SCREWS
___2- ¾ #8 FLAT HEAD SCREWS
___4-FLAT NUTS
YOUR PANEL COMES TO YOU WITH A PROTECTIVE LINER. DO NOT
REMOVE THIS LINER UNTIL PROMTED BY INSTRUCTIONS!
This all new filler panel is a two piece system designed to be assembled around the
flow master exhaust in such a way as to allow a beautiful and gapless appearance. When
installed correctly it will appear as a one piece unit offering a nice custom look for years
of enjoyment. In order to install this filler panel simply follow these few steps.
1. Thoroughly clean the bottom two flat areas of the C-6 valence with alcohol to remove
any road dirt and grime then swipe once with the adhesive promoter provided.
2. Place the larger bottom section of the filler panel in place to get acquainted with the
position and also to determine if any adjustments to the exhaust system will be necessary
such as left and right positioning as well as up and down. It is important to know that in
any aftermarket exhaust system although it may not be readily evident the position of the
tips can be unsymmetrical. Meaning the one set of tips can be higher or lower then the
opposite one as well as their position right to left. If you consider that the accessory you
are about to install has been made perfectly symmetrical in order to successfully install
this panel the exhaust tips must also be positioned perfectly symmetrical. If you find that