American Car Craft Corvette Front Tag Plate Perforated 1997-2004 C5 & Z06 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C5 STAINLESS PERFORATED FRONT NOSE PLATE INSERT
PART #032019
PARTS INCLUDED:
___ 1-Stainless Perforated Insert
___ 1-Adhesive Promoter Pack
___ ¼” Half Round Chrome Molding 41”
Your new insert is a unique accessory that offers a dual purpose. First it offers a
performance styling and a great place for you to add the emblem of your choice. Second
it also offers you a real way to increase air flow to the engine air intake system if you so
choose (SEE Step 2).
INSTALLATION INSTRUCTIONS
1. Remove the factory nose plate by locating the two small screws just under and
inside the lower groove of the plate.
2. At this point you may elect to cut the center area of this opening to allow more air
flow into your engine bay. Since this area is made of a thin urethane it will be
possible to just trim out this area a little at a time until you reach your desired
opening size. NOTE: Just be sure NOT to remove the two factory screw holes just
in case you decide at some point to replace the factory panel.