American Car Craft Corvette Alternator Cover Polished 2005-2013 C6 all - Manual (Page 2)

body and the wire harness should be pushed down allowing the new cover to slide
over the wire harness. (see pictures) Once in position manipulate the new cover so
that it sits squarely on the alternator bracket and forward enough so that the two
holes line up top dead center of this bracket and mark the holes with a fine point
marker.
3. Once you are satisfied with the location and have marked the position remove the
new cover completely. Using a center punch accurately drill into the soft
aluminum bracket using a 9/64
th
drill bit about ½” down. NOTE: This in no way
will threaten the integrity of the stock bracket.
4. Once the 2 holes have been accurately drilled you can now begin the final
installation. Partially remove the protective liner from the long tongue, just past
the mounting holes and reposition atop the alternator bracket, visually line up the
holes. Place one of the small sheet metal screws (provided) thru one of the clear
white button cover sockets (provided). Install the screw being careful not to over
tighten! A HELPFUL TIP! Once one of the screws has been installed re-pilot the
remaining hole (this will insure that the last screw goes in nice and straight) blow
off any shavings and install the last screw.
5. Snap on the 2 chrome screw covers (provided). Be sure they SNAP in place.
Remove the remainder of the protective liner.