American Car Craft Chrysler 300 _ Dodge Charger_Magnum SRT 8 Engine Harness Cover Polished 2005-2010 - Manual (Page 2)

front bolt studs in front of the valve cover. Simply pull up on the harness at the two
locations and completely detach it.
2. You will notice that the harness is kind of spidered up to its connections and that one
of the connections leads up to the top of the air intake tube. Temporarily separate the
air tube connection by loosening the clamp and pulling it loose from the throttle body.
With the tube separated force the harness so that it will wrap around the right side of
the round opening and then under the throttle body. It may be necessary to slice the
electrical tape banding slightly in order to allow you to do this. Once the wire has been
successfully rerouted replace the air tube and clamp. Because the harness has been
released from the valve cover and some of the banding opened up some you will have
enough slack in the harness to achieve this re routing however you may have to get a
little tough with it and pull the harness forward to gain the small amount of slack
needed to do the rearrangement so that the connections do not become to tight.
3. Now that the harness has been successfully rearranged the next step will be to
temporarily remove the front upper bolt of the throttle body just to the left of the air
tube.
4. Place the new cover over the two bolt studs of the valve cover and work the cover
down into position as you manipulate the large vacuum hose into the large notch at the
top of the cover. As you work the cover down line up the front hole with the bolt hole
you just exposed at the front and then reinsert the factory bolt through the new cover
and back into the throttle body and tighten.
5. You have been provided with two small nuts to be threaded over the two factory bolt
studs at the back of the new cover. Once you have inserted them simply snip off the
excess stud with a small bolt cutter. You have been provided with three decorative nut
covers. Using clear 100% household silicone simply applies a small dab into each of the
three covers and set them in place allow a couple of hours for the caps to set.
If any questions occur during installation please call American Car Craft at
727-861-1500.
Thank you and enjoy your purchase!
CARE AND MAINTENANCE:
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust
your cover with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free
glass cleaner.