American Car Craft Camaro Front Header Plate Polished 2010-2013 - Manual (Page 2)

1. The first thing you will need to do is to set the header plate into position and press
the two ends down and force the plate to shape to the slight contour of the factory
header.
The panel should flex to the point that the small holes on either end will come close
enough to the factory header to allow you to mark their two locations. Remove the
panel.
2. Using a 9/64 drill bit pilot the two hole locations. Remove the protective liner and
then set the plate back into position and insert the two ¾ pan head screws through the
small white nylon cap sockets provided and install them into both of the holes and snug
the panel down. NOTE: Do not over tighten as this will tend to distort the panel just
snug will do just fine. Press on the two chrome caps to finish the installation.
If any questions occur during installation please contact American Car Craft @ 727
861-1500.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520
www.americancarcraft.com