American Car Craft Challenger 5.7 and SRT 8 Door Arm Control Trim Brushed 2pc 2008-2013 - Manual (Page 2)

1. Once your areas have been prepared use the adhesive promoter
packs/tubes (provided) to wipe the areas of your dash/door that will be
covered with your new stainless pieces. Allow a few seconds to dry. You
have been provided with
attachment tape test strips
. Use one of
these to test the tack. If it seams to stick well then you can proceed with your
installation. If you can not get the test tape to stick please refer back to the
special preparation instruction sheet and repeat those procedures.
2. IMPORTANT!! Before you remove the liner for permanent attachment
place each piece into position and check the fit and also get acquainted
with just how each part sets in place. It WILL be necessary to form a few
of the parts by hand to CONFORM to the shape of your dash to insure a
nice perfect fit without forcing the shape. Once you are satisfied with the
shape and fit peel the red release liner and firmly press each piece into
position.
If you have any questions during installation please call American Car Craft
at 727-861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com