American Car Craft Dodge Challenger Hood Scoop Overlay Style 2Pc Polished 2008-2013 - Manual

AMERICAN CAR CRAFT INSTRUCTION
CHALLENGER 2pc OVERLAY STYLE HOOD SCOOP GRILLES
PART # 152013
PARTS INCLUDED:
___2-Stainless Hood Scoop Grilles
___1-Adhesive Promoter Pen
1. Thoroughly scrub the factory hood scoop grilles clean with household Isopropyl
Alcohol (or rubbing alcohol) remove any and all waxes and dirt.
2. Once properly cleaned take a piece of masking tape. Stick the test tape strip to the
area in where you will be mounting your new trim. Test several areas, if it is tacky and
sticks then proceed to the next step. If it is not sticking very well in any of the spots you
tested then re-clean the area until the test strip sticks to all areas. If the test strips tape
doesn't stick well neither will your new trim piece.
3. Take your promoter pen included and wipe down the black plastic hood intakes
where the new stainless steel grilles will mount. This clear promoter will not harm your
plastic or paint. Let dry for three minutes.
4. Take each of your new stainless steel grilles and hold them up to the air scoop
intakes on your hood so you become familiar with how they fit.
5. Now take one of the stainless steel grilles and remove the red liner around the
perimeter exposing the sticky side of the tape underneath. Press the new grille inside
the air scoop and hold firming for one minute.
6. Repeat process for the other side.