American Car Craft Camaro Rear Valance Perforated Fits the GM RS Ground Effects 2010-2013 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
2010+ Camaro Rear Valance Trim Perforated
Part #102036
PARTS INCLUDED:
1-Trim Pieces
2-Tube Adhesive Promoter
Introduction: In the next few paragraphs we will explain to you what you will need to know and do for a successful
application of ACC Stainless Steel Accessories. It is important to understand that almost all stainless steel peel and stick
accessories need to be pre shaped by hand in order to achieve a nice long term installation. We realize that all parts are
different from each other but as far as the installations of these parts they all will need to follow the same set of general
instructions.
Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place until the
installation is complete to prevent finger prints and or possible scratches during installation. This liner is required to
remain on the part until you are instructed to remove it.
1. The first thing that needs to be done in any peel and stick application is surface preparation. It is
important that you examine the surface to determine if any kind of special treatments have ever been
used. Such as wax/silicone treatments and/or polymer surface preps. Take a strip of masking tape and
press it very firmly to make it adhere to the surface. Then peel it off to see how difficult it is to
remove. If your masking tape is removed extremely easy and/or does not stick at all then you will
need to perform a special surface preparation. In most cases like this you will need to make a solution
of a straight detergent (Johnson’s Baby Shampoo or Palmolive Dish Soap) and water. Mix a 32oz
bottle with about five table spoons of soap detergent. Once you have the solution made wash the
surface scrubbing quite vigorously to remove any surface contaminates.