American Car Craft Camaro Inner Fender Liners Polished 4pc w_Lit Top Caps w_factory hood 2010-2013 User Manual
Page 2
1. The first step will be to prepare the inner fender ridges to receive the parts. Thoroughly scrub clean the
upper inside area of each fender with alcohol to remove any and all road grime and dirt. Then swipe the
areas with the adhesive promoter provided.
2. Before you actually stick anything take a moment to place each section of the four piece kit into their areas
to get acquainted with their positions and just how you will place the sections. This is important because
the adhesive of each piece is very aggressive and will not allow you to reposition any section should they
make contact in the wrong spot without damaging them so go slow and sure. The first section to go in will
be the self-stick bracket.. Then mount the remaining bracket opposite side.
3. Once you have successfully installed both light rails remove the protective liner and wrought the wires
over to the passenger side positive terminal. At this time in the installation you can proceed to connect the
red light system to whatever type of switching system you will use such as a wireless remote and or
manual type switch. You have been provided with a fuse holder and 5amp fuse. It is important not to
exceed this amperage as this will damage the LED’s. It is also important to understand that the Led lights
will only operate in the correct polarity black wire to ground and black wire with color tracer to the
positive terminal of your switch.
If you have any questions during installation, please call American Car Craft at 727.861.1500.
Thank you and enjoy your purchase!
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520