American Car Craft Camaro Wheel Well Molding Kit Chrome 1" Vinyl 4Pc 2010-2013 - Manual (Page 2)

2. Swipe the adhesive promoter along the wheel well at all four locations and allow a
few seconds to dry.
3. Each of the moldings has been marked for placement. F.D. Front Driver etc.. Peel a
small length of the red release liner from the back of the molding and then set the
exposed adhesive at the side of the wheel well. Place the correct end of the molding
directly to the paint and work the molding along the fender edge as you pull the liner
until you reach the other side then press firmly to set the molding. Because it can not be
exactly calculated how much you may or may not stretch the molding and temperatures
can vary during installation you may have some extra molding by the time you have
reach the end of the installation. Should this occur simply snip any excess molding off
making sure that you achieve the same angle as the body.
DO NOT GET WET FOR 24 HOURS!
If you have any questions during installation please call American Car Craft at 727-861-
1500.
Thank you and enjoy your purchase!
Care and Maintenance:
Wash and wax molding kits regularly to insure a beautiful long lasting finish.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520
www.americancarcraft.com