American Car Craft Mustang Air Box Cover Perforated V8 & GT 5.0 2011-2013 for K&N Intake System KN-63-2578 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
2011-2013 Mustang K&N Intake Box Cover /Polished Perforated
Part #273048
INCLUDES:
1-PERFORATED INTAKE COVER
2-#6 FLAT HEAD SCREWS
Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place until the
installation is complete to prevent finger prints and or possible scratches during installation. This liner is required to
remain on the part until you are instructed to remove it.
1. Remove the K&N Intake Cover.
2. You will need to remove the (5) outer screws. These will be re-used when installing the new cover to the top of
the K&N intake cover.
3. Set the new stainless top plate on the K&N cover and install the (2) screws in the inner holes of the new top
plate. It is not necessary to pre-drill holes for the inner (2) screws. (see example 1)