American Car Craft HHR Fuse Box_BCM Cover Plates Polished 2006-2012 User Manual
Any products
AMERICAN CAR CRAFT INSTRUCTIONS
HHR POLISHED FUSE BOX/BCM TRIM PLATES
PART#423004
PARTS INCLUDED:
___2-Stainless Covers
___1- Adhesive Promoter Pack
Your covers come to you with a protective liner. Do not remove liner until
installation is complete.
1. The first thing that must be done in order to install your new kit is to prep the surface
area of both the fuse box and BCM cover. THIS IS A VERY IMPORTANT STEP!
PLEASE FOLLOW CLOSLEY! Scrub these areas firmly first with household acetone,
let dry then with household isopropyl alcohol, let dry and be sure to remove all flash
residues from the surface. This composite plastic is stain resistant from the factory and is
difficult to bond to, so be sure to scrub these areas very well. Once completely scrubbed
swipe the areas once with the adhesive promoter (provided).
2. Place the stainless steel covers into place and make note of their position. It may be
necessary to slightly form by hand so that they CONFORM to the shape of the factory
cover and lie FLAT WITHOUT FORCING. Once you are satisfied with the fit remove
the red liner and reposition plates. Press firmly to set.
3. Remove protective liner.
If you have used
any products
to make your
engine
cover "shine" you will need to make an extra
effort in cleaning and preparing the surface for
installation.
Returns are allowed only for parts with manufacturing
defects. Installation errors are not manufacturing
defects and parts can not be returned do to improper
installation.