American Car Craft Corvette Fender Trim Plates 4Pc Brushed 2010-2013 Grand Sport Only User Manual
Page 2
1. Thoroughly scrub clean the painted surface with alcohol to remove any and all road grime and dirt. Test that you have
achieved this by applying a strip of masking tape to see if the tape sticks well .if it doesn't repeat the procedure until it
does. Once you have achieved a nice clean bondable surface apply the adhesive promoter provided in your kit. This
chemical is not a cleaner but an adhesive accelerator and must be used to insure a long term bond. Apply one thin and
complete swipe to the painted surface.
2. Before you permanently attach your new parts begin by placing them in position to become acquainted with their
placement and to check there overall shape. Tweak the shape and practice placing them into position a couple of times
before you remove the liner. The adhesive on the parts is very aggressive and will not allow you to reposition the panels
should they make contact in the wrong position. So go slowly and sure.
3. When you are ready peel the red release liner from the back of each section and then carefully set them in place
pressing very firmly along there lengths to set the bond. Remove the protective liners to finish the installation.
4. You have been supplied with 4 precut strips of molding that if you choose can be applied to the factory paint that runs
along the edges of the stainless plates that you just installed which would cap off the edges of your new plates.
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520