American Car Craft Corvette Full Length Outer Doorsills Laser Etched 2Pc 2005-2013 C6 - Manual (Page 2)

3. THIS STEP IS VERY IMPORTANT!!! Gently pre-bend the sills to fit. The
metal is flexible enough to allow you to gently curve it so that the sills fit and
conform to the door area without forcing it to lay flat. You want the doorsills
to look like they are attached (to conform to the shape of the car without any
of the doorsill sticking up from the car) to the car before you actually remove
the red liner.
4. When you are satisfied with the fit, remove the red liner from the attachment tape
and firmly press.
IT IS VERY IMPORTANT THAT YOU SLOWLY INSERT THE SILLS
INTO PLACE, KEEPING THE LARGE FLAP AWAY FROM THE CAR.
THE ATTACHMENT TAPE IS VERY RELIABLE AND IT MIGHT BE A
GOOD IDEA TO MAKE A COUPLE OF TEST FITS BEFORE PULLING
THE RED LINER!
YOU HAVE ONLY ONE SHOT AT THIS SO GO SLOWLY!
5. Once in place pull the protective liner off the sills.
6. OPTIONAL STEP: You have been provided with two lengths of 1/8” chrome
molding. This has been supplied should you elect to use the trim to close the
small space between the tongue of the sill and the painted surface of the car.
To apply swipe a thin bead of the remaining adhesive promoter directly to
the paint surrounding the tongue of the stainless sill. Begin by peeling back a
small portion of the red release liner as you place the trim onto the paint
directly against the new stainless sill, work your way along the edge as you
pull the liner pressing the molding firmly to set the trim into position. As you
approach the end simply cut the excess molding with a scissor or snap knife
and press the end firmly to set.
If you have any questions during installation please call American Car Craft at
727 861-1500. Thank you and enjoy your new purchase.
Note: Care must be taken when cleaning your sills. It is a good idea to lightly dust
your sills with a clean soft cloth first in order to prevent any particles from
scratching them. Then wipe (using a new clean soft cloth or bounty paper towel)
with a good quality streak free glass cleaner.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com