American Car Craft Challenger Door Badge Plate Brushed with Blue MOPAR Omega "M inlay 2Pc 2008-2013" User Manual
Page 2
We can not be responsible for kits not sticking do to improper preparation!
NOTE:
Installation errors are NOT manufacturing defects and parts can NOT be
returned due to improper installation.
1. Once your areas have been prepared use the adhesive promoter packs/tubes
(provided) to wipe the areas of your dash/door that will be covered with your
new stainless pieces. Allow a few seconds to dry. You have been provided with
attachment tape test strips. Use one of these to test the tack. If it seams to
stick well then you can proceed with your installation. If you can not get the
test tape to stick please refer back to the special preparation instruction sheet
and repeat those procedures.
2. IMPORTANT!! Before you remove the liner for permanent attachment place
each piece into position and check the fit and also get acquainted with just how
each part sets in place. It WILL be necessary to form a few of the parts by hand
to CONFORM to the shape of your dash to insure a nice perfect fit without
forcing the shape. Once you are satisfied with the shape and fit peel the red
release liner and firmly press each piece into position.
If any questions occur during installation please contact American Car Craft @
727-861-1500.
Thank you and enjoy your purchase!
American Car Craft
18924 Sakera Rd.
Hudson, FL. 34667
727.861.1500