American car craft – American Car Craft Camaro Lip Spoiler Polished Front GM SS V8 with RS Ground Effects 2010-2013 User Manual
Page 2
When this is done you can proceed to the regular preparation. This is done by scrubbing the surface with alcohol and
wiping it dry. At this point you will need to test the surface again to see if you have achieved a tack. Apply a new strip of
masking tape to the surface. If it adheres you have done a good job, if it doesn’t then you must perform the wash again
and again if necessary until you have achieved a nice tack. Once a tack has been achieved swipe the entire surface to be
mounted with the adhesive promoter you will receive with any of our stainless steel kits. This promoter is not a cleaner
but an adhesive accelerator when used on a nice clean and well prepared surface this chemical will create a very reliable
bondable surface.
2. Now that all preparations have been made the next step will be to apply the accessory. In almost all cases it
will be very necessary to pre-shape the stainless part so that it conforms to the surface you are mounting it to, perfectly.
This is done by gently shaping the part by hand a little at a time so that when the part is placed in position it matches the
surface without having to apply pressure anywhere on the part to make it fit the shape of the surface. In other words it
will look like it has been installed perfectly, before you actually peel and stick it. If you take your time when forming the
part you will never have any problems with the part popping off in the future.
3. Now that you have a good surface prep and your part or parts have been hand shaped to match the surface
you can peel the red release liner from the back of the part. Keep in mind that the adhesive is very aggressive and it will
not allow you to reposition it once it has made contact with the surface. So go slow and sure. Once all hole and the
perimeters are lined up, set the part in place pressing firmly along the entire surface to bond the part and then remove
the protective liner. The bond will become permanent after twenty-four hours.
4. The spoiler should be set to the vehicle at this point well enough to allow you to let it go and then install all
thirteen washer head screws. You have been provided with thirteen flat nuts to be applied to the inner side of the
ground effects in order to insure the lip spoiler remains secure in all road conditions. In order to install the flat head
washers, remove all retainers from the under-side of the front bumper. This will allow you to reach your hand in and
hold the flat nuts while installing the screws.
Disclaimer: Do to the fact that ACC has no control over the preparation and or diligence of the installer’s skill to use all
parts and procedures according to the instructions provide, ACC is not responsible for any damages and/or injuries
caused by the removal of these parts and assumes no liability for improper installation.
If you have any questions during installation, please call American Car Craft at 727.861.1500.
Thank you and enjoy your purchase!
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520