American Car Craft Challenger Water Tank_Power Steering Cover Polished Mopar Slot w_caps 5.7L _ SRT8 6.1L 2008-2011 User Manual
Page 2
1. Remove the water tank pressure cap as well as the power steering cap. Remove the factory
bolt just above and to the right side of the tank. NOTE: This factory bolt will not be reused.
2. Place the new cover over the tank and align the bolt hole with the one on the cover and
fasten using the pan head screw provided. Be carefully not to OVER tighten the screw as this
will distort the new cover. Just snug will be sufficient.
3. Replace the power steering cap. You have been provided with a replacement pressure cap.
To install this cap set it in place and with the palm of your hand push down firmly and twist it
on making sure it is fully rotated. Remove protective liner.
4. You have been provided with a chrome decorative cap cover, with the two tank caps in place
simply clean the factory cap with household alcohol and then swipe once with the adhesive
promoter provided then install the chrome cap by using the Velcro attachment cookies that are
attached to the underside of the new chrome cap. You have been provided with a small chrome
decorative cover for the pan head screw. This small cap has butyl attachment putty attached to
the underside of the cap. This putty is very reliable and need only to be pressed onto the screw
head with firm pressure.
If you have any questions during installation please call American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 | Fax: 727 861-1520