American Car Craft Corvette Plenum Cover Low Profile Perforated Illuminated 1997-2004 C5 & Z06 User Manual
American car craft instructions

AMERICAN CAR CRAFT INSTRUCTIONS
C5 LOW PROFILE PLENUM COVER
Part#033069
Lit Version
Parts Included:
1x Low Profile Plenum Cover
2x Strips of Velcro Attachment Tape
1x Pack of Adhesive Promoter
1x 2pc Decorative Chrome Fuel Pressure Regulator Cover
1x Test Kit
Introduction: This accessory is truly the best ACC has to offer to date. A beautifully hand crafted and hand polished 304
stain less steel work of art. This cover will set atop your C5 fuel rail covers in a low profile position and when “lit” it will
make your engine appear as if it is red hot and ready to launch. This is a truly awesome piece for the discriminating
custom car enthusiast. There is nothing else on the market that offers this special look. We offer an unconditional
money back guarantee if you are not completely and utterly impressed.
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation.
1. Surface Preparation: Your new cover is designed to attach to your existing stock fuel rail covers via Velcro
tape. PLEASE NOTE: If silicone treatments have previously been applied to your fuel rail covers please refer
to the special preparation instructions attached. If silicone treatments have not been applied then continue
by first removing all road dirt and grime with soap and water. Then scrub your fuel rail covers along the
entire most inner corner with household isopropyl alcohol. (This is where your new plenum cover will sit).
Let dry then wipe same area with the adhesive promoter (provided).
2. You have been provided with a decorative plastic chrome fuel pressure regulator cover, located on the
driver side of the factory plenum. Dab a small amount of common household 100% silicone (clear) to the
regulator, set the half cut cover onto the regulator and then install the round bezel over the remaining end
to completely cover the regulator. This will nicely trim the regulator in chrome.
3.