beautypg.com

American Car Craft Corvette Hood Graphic Fade Large 2006-2013 Z06+ZR1+GS User Manual

American Car Craft For the car

background image

AMERICAN CAR CRAFT INSTRUCTIONS

C6 Z06 FULL GRADIENT HOOD FADE GRAPHIC

PART#042031


PROFESSIONAL INSTALLATION RECOMMENDED

You will need: Parts Included:
32-oz Spray bottle 1-Full Gradient Hood Graphic
Household snap knife 2-Lettering Graphics
Lint fee cloth or paper towels (Bounty) 2-Adhesive Promoter Pack
Grease Pencil 1-Soft Squeegee
Heat Gun or Household Hair Dryer 1-Plastic Squeegee

1. Scrub the hood area with household rubbing alcohol to remove all dirt and

wax. PLEASE NOTE: Cars that have been treated with a polymer type paint
sealant need to be professionally removed with specific chemicals not
available to the general public. You will need to take your car to a
professional graphics installer.


2. Mix an application fluid of 32oz water (a full spray bottle) and a few drops of

pure dish detergent or baby shampoo. Test the solution by spraying a corner
of your nose section directly to the paint and look to see if the mixture
“sheets” the surface. If the solution “beads” the surface add another drop or
two of soap until the mixture “sheets” the surface being careful not to make
your solution too soapy as this will cause long term adhesion problems!


3. Once your hood area is thoroughly cleaned, swipe the sides of the bulge in

the hood, the very back edge of the hood as well as the rim of the vent
opening and the gap between the hood and nose ONLY with the adhesive
promoter provided. PLEASE NOTE: DO NOT SWIPE THE ENTIRE
HOOD AREA AS THIS WILL RUIN THE INSTALLATION! The
application of this adhesive promoter in these specific areas will help the
lettering and the edges of the graphic to remain adhered and reduce the
possibility of lifting after a long period of time.