American Car Craft Dodge Challenger 5.7 and SRT 8 Headlight Surrounds Brushed 2008-2013 User Manual
Page 2
2. You have been provided with four strips of chrome molding. Two of these moldings
will be longer then the other two and will be applied to the outer openings of the
factory bezel.
3. Take a look up at the top of each whole opening. You will notice that the openings are
cut off and flat at the very top. NOTE: The moldings will not cover these areas. Peel a
small length of the red release liner from the back of each section of molding and apply
it directly to the corner of the opening and apply pressure to set the molding so that it
sets nice and flush with the outside edge. Set the molding all the way around to the
opposite side and snip off any excess molding with a scissor. Press firmly along the
entire length to set. Do this for all four whole openings.
4. Now that you have each of the four holes lined with the chrome molding you can
apply the outer bezel. Before you permanently install the bezel place it in position to get
acquainted with the proper position. You will notice that the holes in the bezel will
slightly overlap the chrome molding and should line up with the outer shape of the
factory bezel. Once you have a good idea how the bezel will set in place simply remove
the red release liner from the back of the bezel and carefully reset it in place. Be sure to
take your time as the adhesive tape is very aggressive and will not allow you to
reposition the bezel once it has made contact so go SLOWLY. Repeat the application for
the opposite side and remove the protective liners to finish the installation.
If you have any questions during installation please call American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520