American car craft – American Car Craft Corvette Side Vent Grilles Perforated 2Pc 1991-1994 C4 User Manual
Page 2
1. Remove the vented body panel from the vehicle. This will require the removal of the
three wheel well screws and the two body bolts one on top and one under the car at the
fender edge.
2. Once the panel has been removed scrub the inner side of the vent tabs thoroughly with
alcohol to remove any and all road grime and dirt. You have been provided with a small
scotch pad. Use this pad to rough the surface of the tabs and then scrub again. After this
is done, swipe the tabs with the adhesive promoter provided.
3. Before you set the new grille place them in position to check the overall fit and also to
get acquainted with just how they will sit in place. NOTE: The best position is one that
will lean more towards the bottom of the vent opening. This will insure that there will be
no gap visible when looking down on the vent opening.
4. Now that the surface of the tabs have been cleaned and prepped simply remove the red
release liner from the attachment tape of the new grille then press them firmly in place to
set the grille. Reinstall the body panel.
5. Repeat process for other side. Do not get wet for 24 hours.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520