American Car Craft Corvette Side Marker Trim Rear 2Pc Laser Mesh Polished 1997-2004 C5 & Z06 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C5 Laser Mesh Side Markers
PART#032031
PARTS INCLUDED:
___2-Stainless Side Marker Trim
___1-Adhesive Promoter Pack
___1-Adhesive Promoter Tube
___2-17” Lengths ¼” Chrome Trim
1. Thoroughly clean the factory plastic side marker with alcohol to remove any and
all wax and dirt. Once this has been done swipe the entire factory lens with the
adhesive promoter pack provided (save enough promoter for the opposite side)
allow a few second to dry.
2. Before you permanently attach the stainless bezel set it in place to get acquainted
with its position. A properly placed bezel will set perfectly centered evenly all
around the perimeter of the factory lens. Once you can see just how it sets in
place, peel the release liner from the back of your new bezel and carefully set in
place. Press firmly along the entire stainless bezel to make sure you have a nice
complete bond.
3. The next step will be to install the chrome trim. Apply a single bead of adhesive
promoter tube (provided) along the outer edge of the factory lens. Make sure that
the end of the chrome trim is nice and square. Pull the red release liner from the
back of the trim and set it at the very bottom center of the factory red lens and
work the trim around the lens at the same time try to set the trim tightly against
the stainless cover. When you reach the start point mark that point by pressing
your finger nail into the trim, doing this will give you an excellent indication
where to cut the excess. Apply a tiny drop of an instant adhesive to the edge of the
trim and then set the two ends together pressing firmly to set the entire length of
the trim.
DO NOT GET WET FOR 24 HOURS.