American Car Craft Dodge Charger _ Chrysler 300 Door Badges with HEMI Carbon Fiber inaly 2Pc Front Brushed 2011-2013 - Manual (Page 2)

1. Once your areas have been prepared use the adhesive promoter packs/tubes (provided) to wipe the
areas of your dash/door that will be covered with your new stainless pieces. Allow a few seconds to
dry. You have been provided with attachment tape test strips. Use one of these to test the tack. If it
seems to stick well then you can proceed with your installation. If you cannot get the test tape to
stick please refer back to the special preparation instruction sheet and repeat those procedures.
2. IMPORTANT!! Before you remove the liner for permanent attachment place each piece into position
and check the fit and also get acquainted with just how each part sets in place. It WILL be necessary to
form a few of the parts by hand to CONFORM to the shape of your dash to insure a nice perfect fit
without forcing the shape. Once you are satisfied with the shape and fit peel the red release liner and
firmly press each piece into position.
If you have any questions during installation please call American Car Craft at 727 861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520
www.americancarcraft.com