American Car Craft Corvette Convertible Dress Up Hoops Polished 2005-2013 C6 User Manual
Very important

AMERICAN CAR CRAFT INSTRUCTIONS
2005-2013 C6 CONVERTIBLE DECK LID HOOPS
PART #
041007
PARTS INCLUDED:
___2-Stainless Decorative Hoops
___1-Adhesive Promoter Pack
___2- 2'' Round Neoprene Pads
These new hoops are made of high quality 304 stainless steel and have been hand
polished and crafted to fit the factory convertible deck lid just behind the seats. They are
a purely decorative part ONLY. The hoops have been time tested for strength of adhesion
and reliability. They are simple to install in just a few steps.
!!!!!VERY IMPORTANT!!!!!
PLEASE READ ALL INSTRUCTIONS BEFORE
BEGINNING YOUR INSTALLATION! YOU
MUST FOLLOW THESE INSTRUCTIONS
EXACTLY OR YOUR NEW HOOPS MAY NOT
ADHERE.
1. The first step for a successful installation is the preparation of the painted area to
be mounted. This is VERY critical for the long term installation of these parts. To
begin you must thoroughly scrub clean the areas to be mounted with a wax and
silicone remover or any other professional adhesive remover of surface prepping
agent. We recommend 3m adhesive remover found in most auto parts stores. If
these agents are not available you can proceed with rubbing alcohol but it will be
absolutely necessary to rescrub the area several same to insure the paint has been
stripped of any and all surface treatment such as wax, paint sealants and any other
such type of surface protections.