American Car Craft Corvette Taillight Grilles Laser Mesh 4Pc Polished 2005-2013 C6 all - Manual (Page 2)

2. (DO NOT SCRATCH YOUR PAINT!! you may elect to put some masking tape
on your painted surface area) set each taillight cover in place and check the overall
shape. Your new grills come to you preformed to match your taillights however it will be
necessary to further shape each grill by hand in order to achieve the best contoured
fitment. Once you have shaped the grills simply peel the red release liner from the back
of the grill and then carefully set them in place pressing firmly along the outer perimeter
to set the bond. Go over the perimeter several times with high pressure and allow 24hrs to
complete the bond.
3. Remove the protective liner. NOTE: You have been supplied with five strips of ¼
chrome trim. This trim is optional. If you take a close look at the taillight lenses before
installation you will notice an irregular perimeter gap of the factory lenses. This gap is
almost undetectable with the factory lenses in place but after applying you new grills this
irregularity will become more apparent. We have supplied this chrome trim to eliminate
this gap. If you elect to use this trim, simply apply a thin bead of adhesive promoter
supplied with the trim to the painted surface directly in front of the grills perimeter. Then
peel the release liner from the trim and apply the trim directly to the paint nice and tight
against the grill. Start at one side of the lens screw tab and work your way around to the
other side and then cut the trim to fit against the tab for the remaining side. You have
been supplied with a fifth strip in the event you may ever have to change a bulb. The
extra trim is added for replacement.
IMPORTANT TECH NOTE: Be sure to allow the top of the new grills to set behind the
lens attachment screw in order to allow removal of the lens.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com