American Car Craft Corvette Grille Polished Billet Aluminum Front 2006-2013 Z06+GS+ZR1 User Manual
Page 2
1. Apply 2” masking tape directly to the paint surrounding the factory grille. This
will protect your paint during installation.
2. Place the new grille directly into the factory grille and check the over all fit.
Although it should not be necessary you may have to adjust the shape of the grille
so that it fits nice and snug to the black plastic grille.
3. Once you are satisfied with the fit you may begin fastening the grille using the six
zip ties provided. It is CRITICAL that the top three zip ties are fastened to the
factory grille in such a manner that they will hold the new grille from sliding
downward. This can be done by slipping the tie thru the top diamond shape hole
in the factory grille then lashing it around each of the vertical bars in the new
grille. This will take some patience and pre-bending the zip tie to hook around
these areas will be very helpful. You may also use a pair of needle nose pliers to
grab the end of the tie and pull it thru. Once you have fastened the grille at all
three top areas you may complete the installation by fastening the three remaining
zip ties at the lower sections of the grille.
4. After all zip ties have been secured in place trim the excess tie straps with an
exacto knife or snap blade and then push the head of the tie to the back of the
grille using a flat head screwdriver.
5. Remove the masking tape
IF ANY QUESTIONS OCCUR DURING INSTALLATION PLEASE CALL
AMERICAN CAR CRAFT @ 727-861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com