American Car Craft Corvette Brake Booster Cover Polished 2005-2008 C6 User Manual
Page 2
3. Slide the new booster cover over the master cylinder flange base and line up the
holes in the booster cover with the holes in the master. CAUTION: Make sure the
booster cover is placed in front of the master cylinder flange and NOT behind! If
the master cylinder is tightened over the booster cover you will crush the new
cover and possibly damage the factory booster.
4. Reposition the master onto the bolt studs as you carefully allow the new cover to
slip over the factory booster. At the same time you will need to effectively align
the new cover over the booster stud bolts. Jostle the assembly into position so as
to allow you to FINGER TIGHTEN (DO NOT OVERTIGHTEN) the two master
cylinder nuts. Remove the protective liner and tighten down (DO NOT
OVERTIGHTEN) the master and cover.
5. You have been provided with two decorative chrome nut covers. Apply a small
dab of 100% clear household silicone to the covers and install them over the two
factory bolts to finish the installation.
6. Replace and secure the factory water tank.
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust
your cover with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak
free glass cleaner. SEE ENCLOSED CARE SHEET!
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new cover.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com