American Car Craft Corvette Hood Vent Grilles Laser Mesh Polished 2006-2013 Z06+GS+ZR1 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
CORVETTE Z06 STAINLESS LASER MESH HOOD VENT GRILLE
PART#042057
PARTS INCLUDED:
1-Stainless Lash Mesh Hood Vent Grille w/attachment tape
1-Adhesive Promoter Pack
1-Small 1.00 inch piece of attachment tape
WARNING: BE CAREFUL NOT DROP THE GRILLE INTO
THE FRONT AIR SCOOP DURING INSTALLATION.
1. Carefully remove the black factory hood vent grille bezel from the hood
opening. The factory hood vent bezel simply snaps in place however it
does have a small square of double face attachment tape securing the
bezel from flying out at high speeds. This tape will have to be removed
from the factory bezel and replaced with fresh attachment tape provided.
Simply rub the square of tape off with thumb then swipe the area once
with the adhesive promoter provided. Then set the new piece of tape into
position and press firmly to set.
2. Prepare the surface of the factory grille that you exposed behind the bezel