American Car Craft Ford Raptor Grille Fascia Front Brushed 2010-2013 - Manual (Page 3)

tricky so try to install it by just manipulating the covers hole over the catch. Before you set the cover you will
need to install two 2” Velcro cookies at the two left and right corner of the bumper recessed area. (#11)
7- Manipulate the hood catch safety release cable through the ¾ hole at the top left area of the fascia and then
work the cover over the hood catch. With the cover set over the catch manipulate the entire cover so that the
two side panels set atop the two round lower grill stoppers. Pull the rest of the hood catch safety latch cable
through the hole just enough to reach the catch and install the cable back into the mechanism. With the fascia in
this position you can further manipulate the side panels to match into the headlight area. The two long tabs that
run along the top of the headlights should sit positively against the radiator support. If they should seam to sit
away from the support pull the cover forward so as to allow you to tweak the bend so that when you set it back
into place the tabs set firmly against the support. You have been provided with two ¾ Velcro cookies to be
installed just behind the two long tabs over the headlights to secure the tabs and prevent them from vibrating
when driving. (# 12).
8- Align the cover to the hood catch bolts you installed earlier and secure the center of the cover using the two
10/32 stainless machine screws provided. At this time the cover should be in place and looking good. You have
been supplied with two ¾ washer head Zink screws. Drill a 9/64 pilot-hole at the two small holes in the fascia
directly into the plastic support and install the two screws securing the outer area of the fascia.
9- Peel the protective liner from the entire fascia. You have been provided with four ¾” Velcro donuts, separate
these donut halves and then peel the release liner from the back of each donut and then place them around the
four screw heads you installed on the fascia. Then take the remaining halves and press them centered into each
of the four chrome decorative 1” screw caps provided. Then place each of the caps over the screw.
10- You have been provided with a single decorative cable cover that contains butyl putty inside it. Remove the
release paper and then simply press this cover in place to cap the safety latch cable as it comes through the
fascia to finish the installation.