American Car Craft Prowler Side Marker Light Plate with Kat Logo 2Pc Polished 1997-2002 User Manual
American car craft instructions

AMERICAN CAR CRAFT INSTRUCTIONS
Prowler Side Marker Light Plates - Polished
Part #822032
GENERAL PART INSTALLATION INSTRUCTIONS
PARTS INCLUDED:
2-Side Marker Light Covers
1-Adhesive Promoter Pack
Introduction: In the next few paragraphs we will explain to you what you will need to know and do for a successful
application of ACC Stainless Steel Accessories. It is important to understand that almost all stainless steel peel and stick
accessories need to be pre shaped by hand in order to achieve a nice long term installation. We realize that all parts are
different from each other but as far as the installations of these parts they all will need to follow the same set of general
instructions.
Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place until the
installation is complete to prevent finger prints and or possible scratches during installation. This liner is required to
remain on the part until you are instructed to remove it.
1.
Wash your Side Marker Lights on your fenders with Rubbing Alcohol. This will remove all the oil on
the surface. Be sure to clean every nook and cranny around the area so that your Trim Plate can get
a good adhesive grip.
2.
Take Trim Oval Covers and put it up to your Side marker light. Center the Cover in the center of the
Marker light. You will see a little bit of Marker light around the exterior of the Cover. Position it as
you want to permanently mount it.
NOTE: You may want to slightly bend the stainless oval covers to match the slight bend in your